1. <track id="yvm0p"><ruby id="yvm0p"><tt id="yvm0p"></tt></ruby></track>
    2. OBD system uses the full Raiders How can I check if my car is equipped with an OBD system? Turn the ignition key to the start position and if the “Service Engine” or “Check Engine” light is flashing b

      2019-09-17 11:19:30 root 298

      OBD system uses the full Raiders

      How can I check if my car is equipped with an OBD system?

      Turn the ignition key to the start position and if the “Service Engine” or “Check Engine” light is flashing briefly, your vehicle is equipped with an OBD system. Under normal circumstances, the "Service Engine" or "Check Engine" lights will automatically turn off after a short flash, indicating that everything is normal.

      What should I do if the OBD indicator lights up and stays lit?

      If the "Service Engine" or "Check Engine" lights are constantly lit, the OBD system has detected a problem. But you don't have to panic. After arriving at the destination, you should first check that the fuel tank cap is covered (remember to turn off the engine when refueling). If the indicator is still on for a while after the cover is over, you should take your car to the repair shop for repair. If left unchecked, your car may waste fuel, cause excessive air pollution, and may shorten the life of the engine.

      What should I do if the OBD indicator lights up and blinks?

      If the "Service Engine" or "Check Engine" light flashes, it indicates that the OBD system has detected a very serious engine problem, such as a fire that may damage the catalytic tank. At this point, you can still drive safely, but you should minimize the time on the road. Do not drive at high speed or trailer. If left unchecked, it could cause serious damage to your vehicle.

      How to read the OBD fault code?

      1) Turn off the engine and the ignition key is in the off position.

      2) Connect an OBD scanning tool (small handheld scanning device, etc.) to the connector interface under the dashboard of your vehicle.

      3) Turn the ignition key to the starting position (you do not have to start the engine).

      4) Open the OBD scanner and read the fault code.

      5) Turn the ignition key back to the off position and unplug the reader.

      6) Use this manual to check the cause of the fault (please note that this manual is for reference only) and perform the corresponding repairs.


      Telephone consultation
      Company address
      Solution
      Contact information
      国产做无码视频在线观看_久久久不卡网国产精品一区二区_2020年国产a√日韩免费_亚洲中文无码a∨在线观看